Sunmax Walk-Behind

Frequently Asked Questions
Turn the key switch to the "ON" position. Then, lower the scrub deck and squeegee assembly to the floor using the lift levers/pedals. Engage the switches for the brush, vacuum, and water/solution flow to begin scrubbing.
Use a neutral pH floor cleaner added to the clean water tank. Avoid using flammable liquids. The machine will mix the water and soap internally.
Yes, add an appropriate amount of defoamer to the sewage/recovery tank to prevent excessive foam from entering and damaging the vacuum motor.
Yes, the brushing and suction functions are typically controlled by separate buttons on the control panel.
Walk at a slow, steady pace, allowing the brush to effectively scrub the floor and the squeegee to pick up the dirty solution. Overlapping each pass slightly (about 2 inches) will ensure complete coverage.
Sunmax scrubbers are suitable for hard floors like tile, concrete, vinyl, epoxy, and sealed wood. For delicate surfaces like sealed wood or laminate, it is recommended to use soft brushes or pads to avoid scratching.